TM 5-6675-318-14
Section Ill TOOL AND TEST EQUIPMENT REQUIREMENTS - Cont
(1)
Reference
Code
18
19
20
(2)
Maintenance
Category
C
O,F,H
F
(3)
Nomenclature
Carrier, Storage
Battery, Hand
Rivet Gun
Wrench, Torque
Section IV REMARKS
(4)
National/NATO
Stock Number
5120-00-017-2849
5120-00-890-7816
(5)
Tool
Number
(43331)
M180
Reference Code
Remarks
D
E
F
A
Printed circuit boards will be repaired at the generaI support maintenance level to the
maximum extent possible as required by AR 750-1.
B
Direct support maintenance will provide printed circuit board diagnosis and fault
isolation which can be readily accomplished with assigned tools and test,
measurement, and diagnostic equipment (TMDE).
C
Replacement of printed circuit beards authorized by the MAC are those identified as
damaged, or otherwise defective which:
a) Can be readily removed/installed with easy to use tools.
b) Do not require critical adjustment, calibration, or alinement before or after
installation.
See TM 5-4120-367-14 for maintenance procedures.
See TM 9-1260-206-12&P and TM 9-1 260-20&34&P for maintenance procedures.
Maintenance personnel and TSS Section 7, Maintenance Van (which carries the
required tools) are authorized by HHC TOE 05336 H600
Change 1
B-11/(B-12
Blank)