TM 5-6675-318-14
Table 3-26. HP-IB ERROR DISPLAYS AND POSSIBLE CAUSES - Cont
Display or Printout
P o s s i b l e Causes
SERVICE REQUEST FAILURES
( 1 ) Failure of control bus latch ROM U1
"INTERFACE REQUESTED SERVICE
or I/0 register selector on PCA A2.
BUT "SRQ IN STATUS BYTE" IS
NOT SET"
(2) Failure of microprocessor.
S a m e as items (1) and (2) above.
" INTERFACE DOES NOT REQUEST
S E R V I C E . CANNOT CLEAR "SQR""
S a m e as items (1) and (2) above.
" I N T E R F A C E INCORRECTLY
RESPONDED TO SERIAL POLL.
CANNOT CLEAR "SRQ" "
INTERRUPT TEST FAILURES
(1) Failure of interrupt loqic, micro-
"IUT WAS ENABLED TO INTERRUPT
processor, or control bus latch on
ON SERVICE REQUEST, BUT NO
PCA A2 .
INTERRUPT OCCURRED"
( 2 ) F a i l u r e o f o u t p u t data latch on PCA
A2.
( 1 ) Same as items (1) and (2) above.
"IUT WAS ENABLED TO INTERRUPT
INTERRUPT ON BECOMING ACTIVE
( 2 ) Failure of computer command register
CONTROLLER, BUT NO INTERRUPT
o r interrupt logic on PCA A1.
OCCURRED"
S a m e as items (1) and (2) above.
"IUT WAS ENABLED TO INTERRUPT
INTERRUPT ON BECOMING ACTIVE
TALKER, BUT NO INTERRUPT
OCCURRED"
Failure of interrupt logic, microproces-
"IUT WAS ENABLED TO INTERRUPT
sor, control bus latch, or data input
INTERRUPT ON BECOMING ACTIVE
multiplexer on PCA A2.
LISTENER, BUT NO INTERRUPT
OCCURRED"
3-249
