TM 5-6675-318-14
Table 3-20. PLOTTER PROGRAMMING LANGUAGE - Cont
Statement Identification and Use
Program
Statement, Syntax, Explanation, and Input Instructions
Statement
scl - Cont
If scaling point P1 is assigned negative (-) coordinates and
P2 is assigned positive coordinates, origin is automatically
If both sets of coordinates for
set at center of plot area.
points are positive, origin will be off paper in lower left
For two negative sets of
corner as shown in illustration.
coordinates, origin is off paper in upper right corner.
S c a l e i s a u t o m a t i c a l l y s e t w h e n p l o t t e r i s i n i t i a l i z e d o r S Cl
statement w ithout parameters is input. Origin is set at P1
a n d p l a t e n s divided into units 1 cm in length.
of P1 and P2 in internal units of plotter are:
Coordinates
P 1 (520, 380) and P2 (15720, 10380)
3-184
