TM 5-6675-318-14
Table 3-10. PLOTTER PROGRAMMING LANGUAGE - Cont
Statement Identification and Use
Program
Statement Syntax, Explanation, and Input Instructions
Statement
l b l - Cont
Value assigned to X will be lettered in current number format
(fixed or float). Value resulting from expression X+1 is
lettered next, followed by value resulting from expression
X+2. Digits in these expressions are lettered as string of
characters. This requires you to add any spaces needed to fit
numbers into context of item being lettered.
F o r example, the following statement letters same expressions
a s example above, with four spaces between each value.
", X+1, "
",
X+2,
"
"
lbl X, "
The following example letters characters contained in string
variable A$. (String variable ROM is required.)
l b l A$
B e f o r e using label statement, pen should be moved to location
where labeling is to begin by using one of plot statements
(cplt, iplt, or plt) or by using four direction controls on
plotter front panel. This point will become lower left corner
of first character. After lettering character, pen stops at
lower left corner of next character space.
C H A R A C T E R SIZE. Specifies size and shape of characters and
csiz
symbols and direction they are to be lettered.
Syntax:
csiz [Height [, Aspect Ratio [, Paper Ratio [, Angle of
Rotation]]]]
Statement can specify up to four parameters. If any of para-
meters are omitted, specific default value for parameter is
a s s u m e d . Note that when parameter is omitted, parameter
listed immediately to its right must be omitted as well.
Here is description of each of four parameters:
Height parameter specifies height of characters as percent of
s c a l e height defined by scaling points P1 and P2. Must be
within range of 0 thru 127.9994999.
3-89
