TM 5-6675-318-14
c.
R e m o v e nut, washer, and screw from each corner of air conditioner/heater
mounting.
R e m o v e screws securing mounting to section.
d.
Disconnect drain line from air conditioner/heater.
R a i s e hoist enough to remove slack
e.
Attach sling
to
lifting
handles.
from sling.
f.
R e m o v e mounting bolts and washers.
Slide out air conditioner until other lifting handles are free. Attach
g.
sling to handles.
h.
Raise defective air conditioner/heater with hoist until unit is free
from brackets and section.
i.
Place air conditioner/heater on flat-bed truck or pallet.
Dry cleaning solvent, P-D-680, used to clean parts is potentially danger-
ous to personnel and property. Avoid repeated and prolonged skin contact.
W e a r soslvent-impermeable gloves and eye/face protective equipment when
using solvent. Do not use near open flame or excessive heat. Flash point
of solvent is 100 F to 138 F (38 C to 59 C).
Clean sealant from opening using dry cleaning solvent P-D-680.
j.
damaged gasket and replace with new gasket.
k.
Raise air conditioner/heater until it rests on air conditioner/heater
l.
brackets.
Remove two sling hooks as unit is eased into hole until grille touches
m.
duct.
R e m o v e remaining sling.
n.
Reinstall washers and mounting bolts.
o.
Reconnect
drain
lines.
p.
Reinstall screws securing air conditioner/heater mounting to section
q.
wall. Reinstall screw, washer, and nut to each corner of mounting.
Reinstall screws securing air duct to air conditioner/heater.
r.
Reconnect or plug in power cord. Turn on air conditioner/heater circuit
s.
breaker.
1-93
