TM 5-6675-317-14
NOTE
Right transilluminator has two lamps and left transilluminator has one lamp.
Procedures for changing lamps are the same for each transilluminator.
c. Unplug light box cord.
d.
Lift light box from rear until front rail disengages from track. Then
lower light box to work surface.
e.
Slide light box out from under scope.
f.
Loosen, but do not remove cover screws.
9*
Slide cover to release and set cover aside.
CAUTION
Fingerprints will damage lamp and cause early failure. Do not touch lamp
with fingers.
Use cotton gloves.
h.
Pull spade connectors from lamp socket.
(Use needle nose pliers as con-
siderable force is required to disconnect.)
i.
Detach spring clip and swing out of way.
j.
Pull lamp socket and lamp from back of reflector with needle nose
pliers.
k.
Remove lamp from socket by pulling back on retaining springs.
1.
Place new lamp into socket. Lamp fits only one way.
3-41
