TM 5-6675-317-14
CAUTION
Removal of five socket head screws located closest to glass surface
may result in damage to equipment.
c.
Remove nine socket head screws and left panel, but do not remove five
socket head screws indicated in CAUTION and illustration.
d.
Pull cabinet assembly lock release and swing cabinet assembly out so
that it is not under table.
Tilt locking plates
positions.
e.
Remove upper
NOTE
are not interchangeable and must be replaced in same
screws, nuts, and washers from defective tilt locking plate.
f.
Tilt table top as necessary and remove defective tilt lock plate by
removing lower screws, nuts, and washers.
g.
Install new tilt locking plate, and secure with washers, nuts, and
screws.
h.
Check position of tilt lock plate and readjust if required.
i.
Remove defective limit control plate by removing screws, washers,
and nuts.
j.
Install
screws.
k.
Reinstall
new limit control plate.
Secure with nuts, washers, and
left panel and secure with nine socket head screws.
NOTE
Use care in disassembly of safety stop to prevent spring from falling inside
frame.
1.
m.
n.
o.
Remove defective safety stop by removing nut, lockwasher, sleeve,
spring, spacer, and screw.
Install new safety stop.
Secure with screw, spacer, spring, sleeve,
lockwasher, and nut.
Swing cabinet assembly to its normal position under table.
Plug in power cord.
2-29
