TM 5-6675-316-14
NOTE
Do not disconnect wires to transducer.
d. Remove three screws, one nut,
chassis.
e.
Tag and disconnect power cord
board.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o .
and one washer holding circuit board to
wires and power switch wires from circuit
Disconnect capacitor wires from circuit board.
Tag and disconnect two transducer wires from circuit board.
Remove defective circuit board.
Install new circuit board.
Reconnect two transducer wires to circuit board.
Reconnect capacitor wires to circuit board.
Reconnect power switch wires and power cord wires to circuit board.
Reinstall one washer, one nut, and three screws holding circuit board to
chassis.
Reinstall stainless steel tank and casing. Secure with screws and
washers.
Fill stainless steel tank 1/3 full with water.
P.
Plug in power cord and
agitates.
10-17. PREPARATION FOR STORAGE
and shipping instructions.
turn power on.
Check that water surface
OR SHIPMENT.
Contact your battalion for packing
Section V DIRECT/GENERAL SUPPORT MAINTENANCE
There are no direct/general support maintenance procedures assigned for this
equipment.
10-17/(10-18 blank)
