TM 5-6675-316-14
WARNING
Use care when handling damaged glass.
Failure to do so may result in
serious cuts.
d.
Remove damaged glass surface.
CAUTION
Glass surface must be handled with care to avoid chipping or breaking.
e.
Install new glass surface.
f. Turn clips to secure glass surface.
Aline holes and reinstall screws.
Tighten all screws.
g.
Plug in power cord and turn power switch ON.
Section IV ORGANIZATIONAL MAINTENANCE
9-11.
LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
9-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIP-
MENT (TMDE); AND SUPPORT EQUIPMENT.
9-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
9-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
9-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-316-24P covering organizational maintenance for
this equipment.
9-17
