TM 5-6675-316-14
c.
Note position of board connectors.
d. Disconnect connectors.
e.
Remove six hex nuts, washers, and defective controller board.
f. Install new controller board.
9.
Reinstall washers and hex nuts.
h. Reconnect board connectors in proper position.
i.
Close cabinet door.
J.
Plug in power cord.
3-20.14 Replace Pen Drive/Tangential Tool Control Board.
MOS :
35E, Special Electronic Devices Repairer
SUPPLIES:
Pen Drive/Tangential Tool Control Board
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before-servicing.
a.
Unplug power cord.
b. Open cabinet door.
3-172
