TM 5-6675-315-14
Section IV ORGANIZATIONAL MAINTENANCE
1-11. LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
1-12. REPAIR PARTS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT; AND SUPPORT EQUIPMENT
1-12.1 Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
1-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools, TMDE,
and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this manual.
1-12.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List, TM 5-6675-315-
24P covering organizational maintenance for this equipment.
1-13. SERVICE UPON RECEIPT.
NOTE
The section may be received mounted on a chassis or as a van body for mounting on an available
trailer/transporter or on site. Inspection of the chassis is covered in TM 5-2330-305-14. Inspection of the air
conditioner/heater is covered in TM 5-4120-367-14.
1-13.1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the damage
on DD Form 6, Packing Improvement Report.
(1)
Visually inspect the section exterior starting at the rear to cover rear, curbside, roadside, front, top,
and bottom. Inspect for damage, tears, breaks, or corrosion.
(2)
Enter section and inspect for broken equipment, tool boxes, chairs, or equipment loose and not
secured.
(3)
Close doors and vents to determine if light leaks exist.
(4)
Inspect doors for damage, torn or rotted seals, and tightness of closure.
1-50
