TM 5-6675-313-14
Table 1-2. TROUBLESHOOTING – Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
NO ELECTRICAL POWER TO SECTION - Cont
Step 4.
Check main circuit breaker position.
(a) If circuit breaker
maintenance.
(b) If circuit breaker
(c) If circuit breaker
supervisor.
2.
NO ELECTRICAL POWER TO EQUIPMENT.
is ON, refer to direct/general support
is OFF, turn ON.
trips repeatedly, notify power supply
Step 1.
Check equipment power switch.
(a) If power switch is ON, proceed to step 2.
(b) If power switch is OFF, turn ON.
Step 2.
Check power cord.
(a) If power cord is plugged in, proceed to step 3.
(b) If power cord is unplugged, plug in.
Step 3.
Inspect circuit breaker panel for breakers in OFF position.
(a) If all circuit breakers are ON, refer to direct/general
support maintenance.
(b) If any circuit breakers are OFF, turn ON.
1-44
