TM 5-6675-313-14
NOTE
Do not disconnect wires to transducer.
d. Remove three screws, one nut, and one washer holding circuit board to
chassis.
e.
Tag and disconnect power cord wires and power switch wires from circuit
board.
f. Disconnect capacitor wires from circuit board.
g.
Tag and disconnect two transducer wires from circuit board.
h.
Remove defective circuit board.
i.
Install new circuit board.
j.
Reconnect two transducer wires to circuit board.
k.
Reconnect capacitor wires to circuit board.
l.
Reconnect power switch wires and power cord wires to circuit board.
m. Reinstall one washer, one nut, and three screws holding circuit board to
chassis.
n.
Reinstall stainless steel tank and casing. Secure with screws and
washers.
o.
Fill stainless steel tank 1/3 full with water.
p.
Plug in power cord and turn power on. Check that water surface
agitates.
5-17. PREPARATION FOR STORAGE OR SHIPMENT.
Contact your battalion for packing
and shipping instructions.
Section V DIRECT/GENERAL SUPPORT MAINTENANCE
There are no direct/general support maintenance procedures assigned for this
equipment.
5-17/(5-18 Blank)
