TM 5-6675-313-14
WARNING
Use care when handling damaged glass. Failure
serious cuts.
d.
Remove damaged glass surface.
Glass surface must be handled w
e. Install
f.
Turn cli
Tighten
g.
Plug in
CAUTION
ith care to avoi
.
to do so may result in
d chipping or breaking.
new glass surface
ps to secure glass surface.
Aline holes and reinstall screws.
all screws.
power cord and turn power switch ON.
Section IV ORGANIZATIONAL MAINTENANCE
3-11. LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
3-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT(TMDE); AND SUPPORT EQUIPMENT.
3-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of O rganization and Equipment (MTOE) applicable to Your
unit.
3-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
3-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-313-24P covering organizational maintenance for
this equipment.
3-17
