APPENDIX B
COMPONENTS OF END ITEMS LIST
Section I. INTRODUCTION
B-1. Scope. This appendix lists Integral Com-
(2) Item Number.
ponents of and Basic Issue Items (BII) for the
target set, azimuth laying to help you inventory
items required for safe and efficient operation.
B-2. General. The components of end item list
are divided into the following sections:
a. Section II. Integral Components of the End
Item. These items, when assembled, comprise the
target set, azimuth laying and must accompany it
whenever it is transferred or turned in. These il-
lustrations will help you identify these items.
b. Section III. Basic Issue Items. These are
minimum essential items required to place the
target set, azimuth laying in operation, to operate
it and to perform emergency repairs. Although
shipped separately packed, they must accompany
the target set, azimuth laying during operation and
whenever it is transferred between accountable of-
ficers. The illustrations will assist you with hard-
to-identify items. This manual is your authority to
requisition replacement BII based on Table(s) of
Organization and Equipment (TOE)/Modification
Table of Organization and Equipment (MTOE)
authorization of the end item.
B-3. Explanation of Columns.
a. Illustration. This column is divided as
follows.
(1) Figure Number. Indicates the figure
number of the illustration on which the items is
shown (if applicable).
The number used to identify
item called out in the illustration.
b. National Stock Number (NSN). Indicates the
national stock number assigned to the end item
which will be used for requisitioning.
c. Part Number (P). Indicates the primary
number used by the manufacturer which controls
the design and characteristics of the item by
means of its engineering drawings, specifications,
standards and inspection requirements to identify
an item or range of items.
d. Description. Indicates the federal item name
and if required, a minimum description to identify
the item.
e. Location. The physical location of each item
listed is given in this column. The lists are
designated to inventory all items in one area of the
major item before moving onto an adjacent area.
f. Usable on Code. Model 242406-CCQ; Model
USATS-79-DGF.
g. Quantity Required (Qty Reqd). This column
lists the quantity of each item required for a com-
plete major item.
h. Quantity. This column is left blank for use
during inventory. Under the received column, list
the quantity you actually receive on your major
item. The date columns are for use when you inven-
tory the major item at a later date, such as for ship-
ment to another site.
B-1
