TM 5-6675-250-20
2-18. CONTROL KNOBS, ECU PANEL.
This task covers:
a . R e m o v al
b . R e p a i r / R e p l a c e
c.
I n s t a l l a t i on
I N I T I A L S E T UP
T o o ls
K e y s e t , h e x h e a d
NSN 5120-01-017-9535
Hex wrench, Size 0.050 inch
M a t e r i a l / p a r ts
MIL-S-22473, Grade N, Form R
Primer, Item 5, Appendix C
Locking sealant MIL-S-46163,
Grade N, Type II, Item 2,
A p p e n d i x C
P e r s o n n e l R e q u i r ed
MOS 82E Surveying
I n s t r u m e n t M e c h a n i c
L O C A T I O N / l T EM
A C T I O N
R E M A R K S
Maintenance instructions given
control knobs on the ECU.
N O TE
in the following procedures apply to all
1 . C o n t r o l k n ob
a.
Remove two setscrews (1) recessed into con-
trol knob.
b.
Remove control knob (2) from control shaft.
Replace defective control knob or setscrew(s) with a
serviceable like item.
2-94
