TM 5-3610-287-24
3-18.
ALIGN EXPANDING SIDE GEAR MECHANICAL (CONT)
Equipment Conditions
Section level and expanded (TM 5-3610-287-10, para 2-6)
Hold front cover plate firmly when removing attaching
hardware. Plate may fall and cause injury.
NOTE
This procedure is performed only when both upper and
lower gear racks on front or rear of expanding sides are
out of time with opposite ends. Alignment must be made
at front speed reducer.
1.
Remove screws (1), hex bolts (2), and front cover plate (3).
2.
Remove hex nuts (4), lockwashers , and hex bolts (5) on timing drive
plates (6).
3.
Count and record number of teeth between wiper seal and outer end of
expanding side on lower gear racks.
3-33
