TM 5-3610-286-20
2-93.
Main Control Box.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Additional Personnel Requirement
Wrench (00.780.0854)
Electrician MOS 35E20
10 mm combination wrench
Printing and Binding Specialist MOS 83F20
12 mm combination wrench
0.046 x 0.3125 x 6 inch flat-tip screwdriver
General Safety Instructions
No. 3 x 6 inch cross-tip screwdriver
Fuse extractor
WARNING
Equipment Conditions
Shut off power source before attempting
to disconnect, service, or connect wires
Main circuit breaker for press OFF
or cables. Failure to do so may result in
(TM 5-3610-287-10)
death or serious injury.
a. Remove. (figure 2-259)
(1) Ensure main switch (1) is in OFF position. Disconnect main power cable from power
source.
(2) Remove door panels (2).
(3) Tag and remove cables and wiring harnesses.
(4) Remove five hex-head screws (3) and three spacers (4).
WARNING
Main control box exceeds 35 pounds. Use
(5) Remove control box (5) from feeder frame.
two persons to remove.
(6) Remove two hex screws (6) from inside of feeder frame and bracket (7).
2-524
