TM 5-3610-286-20
Compressor.
2-91.
This task covers:
a. Test
b. Replace
c. Repair
INITIAL SETUP
Tools
General Safety Instructions
0.050 x 0.375 x 8 in. flat-tip screwdriver
WARNING
1.0 x 6.0 x 0.5 mm flat-tip screwdriver
No. 2 x 4 inch cross-tip screwdriver
Hazardous electrical voltages exist
No. 3 x 6 inch cross-tip screwdriver
within printing press. Do not connect
8 mm combination wrench
or disconnect any electrical components
19 mm combination wrench
while power is on. Death, serious elec-
3 mm hex key
trical shock, or burns may result.
Additional Personnel Requirement
Electrician MOS 35E20
a.
b.
Test. Test performance as described in troubleshooting, para. 2-10.
Replace. (figure 2-256)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
2-518
NOTE
Procedure is for oil lubricated compressor. Procedure for dry (oilless)
compressor is identical.
Loosen four hose clamps (1) and remove hoses (2).
Remove four slotted screws (3), cover (4), and terminal box (5).
Remove three terminal hex nuts (6) and tag and remove black leads (7).
Remove one cross-head screw (8) and cover (9).
Loosen two slotted screws (10) and tag and remove two leads (11).
Remove four fat-head screws (12), fiat washers (13), and Iockwashers (14).
Slide compressor (15) out and turn it on its side.
Remove four cross-head screws (16), and mounting plate (17).
With compressor (15) turned on its side, install mounting plate (17) and four cross-head
screws (16).
Turn compressor (15) so that mounting plate (17) is down and slide compressor into
position next to press.
