TM 5-3610-286-10
Table 3-1.
Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
11.
FEEDER KEEPS TRIPPING OFF.
Step 1.
Check for correct feeder settings.
Adjust feeder (para 2-7b (1) and (2)).
Step 2.
Check adjustment of double sheet detector.
Adjust double sheet detector (para 2-7b (3)).
Step 3.
Check for cleanliness of light barrier.
Clean light barrier (table 2-1, item 4).
Section III. MAINTENANCE PROCEDURES
3-3. GENERAL.
This section contains operator maintenance instructions
authorized by the maintenance allocation chart (MAC) in TM 5-3610-286-20,
appendix B.
The following topics are included as applicable:
a. Removal
b.
Cleaning c. Repair d. Installation e. Adjustment. All
maintenance procedures in this chapter will be performed by one Photo-
lithographer MOS 83F20.
The Printing Press must be shut down to perform
maintenance procedures unless otherwise stated in the initial setup.
3-4.
INKING ROLLER MAINTENANCE INSTRUCTIONS
This task covers: a. Removal b.
Cleaning
c. Repair d.
Installation
e. Adjustment
INITIAL SETUP
Tools
Special L-handle wrench (appendix B, section III, item 45)
Curved pin wrench (appendix B, section III, item 41)
Rubber mallet (appendix B, section III, item 24)
Bearing puller (appendix B, section III, item 30)
Bearing guide (appendix B, section III, item 14)
13 mm combination wrench (appendix B, section III, item 39)
Roller supports (appendix B, section III, item 34)
19 mm T-handle socket wrench (appendix B, section III, item 44)
3-9
