TM 5-3610-286-10
1-1. SCOPE. This manual contains operating and operator’s maintenance instructions for the Topographic
Support System (TSS) Press Section Printing Press Model SOR, 3610-01-214-1245. Organizational maintenance
instructions for the Printing Press are contained in TM 5-3610-286-20. The TSS Press Section Printing Press
provides printing support for topographic units. The Printing Press must be housed in a temperature- and
humidity-controlled environment with access to electrical power and water supply. Operating and operator’s
maintenance instructions for the Section that houses the Printing Press are contained in TM 5-3610-287-10.
Organizational, direct support, and general support maintenance instructions for the Printing Press Section are
contained in TM 5-3610-287-24. Repair parts and special tools for the Printing Press are listed in TM 5-3610 -286-
20P, and those for the Section are listed in TM 5-3610-287-24P. For lubrication instructions for the Printing Press,
refer to LO 5-3610-286-12; for lubrication instructions for the Section, refer to LO 5-3610-287-12. The Press
Section is mounted on a flatbed semitrailer chassis. Operating and maintenance instructions for the semitrailer
chassis are contained in TM 5-2330-305-14. In case of conflict with the contents of any referenced document, the
contents of this manual will be followed.
1-2. MAINTENANCE FORMS AND RECORDS. Department of the Army forms and procedures for forms
used for equipment maintenance will be those prescribed
Management System (TAMMS).
1-3. HAND RECEIPT (-HR) MANUALS. This manual
by DA PAM 738-750, The
has a companion document
Army Maintenance
with a TM number
followed by -HR (which stands for hand receipt). The TM 5-3610-286-10-HR consists of preprinted hand receipts
(DA Form 2062) that list end item related equipment (i.e., COEI, BII, and AAL) you must account for. As an aid
to property accountability, additional-HR manuals may be requisitioned from the following source in accordance
with procedures in chapter 3, AR 310-2: The U.S. Army Adjutant General Publications Center, 2800 Eastern
Boulevard, Baltimore, Maryland 21220-2896.
1-4. REPORTING EQUIPMENT IMPROVEMENT RECOMMENDATIONS (EIRs). If your Printing
Press needs improvement, let us know. Send us an EIR. You, the user, are the only one who can tell us what you
do not like about your equipment. Let us know why you do not like the design or performance. Put it on an SF
368 (Quality Deficiency Report). Mail it to us at Commander, U.S. Army Troop Support Command, ATTN:
AMSTR-MOF, 4300 Goodfellow Boulevard, St. Louis, Missouri 63120-1798. We will send you a reply.
1-5. WARRANTY INFORMATION. The TSS Press Section Printing Press is warranted by Heidelberg East
for six months after installation into the Section. Parts are warranted for one year after installation. Warranty
starts on the date found on DA Form 2408-9, shipped with Printing Press Section. Report all defects in material
or workmanship to your supervisor who will take appropriate action.
1 - 2
Change 2
