TM 5-3610-285-24P
(2)
FIG. Column. This column lists the number of the figure where the item is identified/located. The figures
are in numerical order in Section II and Section III.
(3)
ITEM Column . The item number identifies the item associated with the figure listed in the adjacent FIG.
column. This item is also identified by the NSN listed on the same line.
b.
PART NUMBER INDEX. Part numbers in this index are listed in ascending alphanumeric sequence (i. e.,
vertical arrangement of letter and number combinations which place the first letter or digit of each group in order A
through Z, followed by the numbers 0 through 9, and each following letter or digit in like order).
(1)
FSCM column . The Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code used to
identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
(2)
PART NUMBER Column. Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by means of
its engineering drawings, specifications, standards, and inspection requirements to identify an item or
range of items.
(3)
STOCK NUMBER Column. This column lists the NSN for the associated part number and manufacturer
identified in the PART NUMBER and CAGEC columns to the left.
(4)
FIG. Column. This column lists the number of the figure where the item is identified/located in Section II
and Section 1II.
(5)
ITEM Column . The item number is that number assigned to the item as it appears in the figure referenced
in the adjacent figure number column.
5. SPECIAL INFORMATION.
a.
USABLE ON CODE. The usable on code appears in the lower left corner of the Description column
heading. Usable on codes are shown as "UOC: ......."in the Description Column (justified left) on the first
line applicable item description/nomenclature. Uncoded items are applicable to all models.
b.
ASSOCIATED PUBLICATIONS. The publication listed below pertains to the Photomechanical Section
and its components.
Publication
Short Title
LO 5-3610-285-12
Lubrication Order: Topographic Support System, Photomechanical
Section
TM 5-3610-285-14
Topographic Support System, Photomechanical Section
TM 5-3610-285-14-HR
Hand Receipt: Topographic Support System, Photomechanical
Section
6. HOW TO LOCATE REPAIR PARTS.
a.
When National Stock Number or Part Number is NOT Known.
(1)
First. Using the table of contents, determine the assembly group or subassembly group to which the item
belongs. This is necessary since figures are prepared for assembly groups and subassembly groups, and
listings are divided into the same groups.
6
