TM 5-3610-285-14
Table 1-5. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. RECEPTACLES DO NOT OPERATE BUT CIRCUIT BREAKERS ARE ON - Cont
Step 2. Check to see if voltage meter and frequency scale and INCORRECT PHASE or CORRECT PHASE
lamp indicate necessary power.
Notify your supervisor for service of power supply at source.
5. CIRCUIT BREAKERS TRIP CONTINUALLY.
WARNING
Turn off and padlock safety switch before inspecting or servicing circuit breakers or receptacles. Failure to
do so may result in death or serious injury.
Step 1. Check to see if receptacles are overloaded.
Reconnect equipment to different receptacles.
Step 2. Check to see if receptacles are damaged.
Replace receptacles (paragraph 1-16.6).
1-20. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering direct/general support maintenance functions for the Photomechanical
Section. Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
1-88
