TM 5-3610-285-14
p.
Remove setscrews connecting motor shaft to blower.
q.
Remove motor mounting bolts, flat washers, lockwashers and nuts; remove defective blower motor from base.
r.
Aline shaft with blower. Install new blower motor on base, and secure with bolts, flat washers, lockwashers and
nuts.
s.
Reinstall setscrews in motor shaft.
NOTE
Rubber spray adhesive on isolator pads will assist in reinstallation.
Allow rubber spray adhesive to dry before proceeding with reinstallation.
t.
Reinstall isolator pads into position under motor base.
u.
Reinstall blower assembly into processor. Secure with mounting bolts, lockwashers and flat washers. Tighten
bolts securely.
v.
Lead blower motor cable through frame to front of processor. Connect new wiring to terminal blocks. Connect
ground wire.
w.
Install cable into retaining clips on side of blower shroud. Secure cable to frame with new wire ties.
x.
Reinstall front control panel and secure with screws.
y.
Reinstall TRANSPORT SPEED control knob and tighten setscrew.
z.
Reinstall fixer recirculation pump assembly to processor frame and secure with bracket and two screws.
aa.
Reinstall metal heat shield and plastic shroud. Secure with screws, socket head capscrews, and flat washers.
ab.
Reinstall grille.
ac.
Reinstall air tubes and dryer rollers.
ad.
Reinstall right and left side access panels.
ae.
Reinstall rear panel.
af.
Turn on processor circuit breaker.
5-167
