TM 5-3610-259-14
Section III.
OPERATOR MAINTENANCE
7.3.1 LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
7.3.2 TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation
or maintenance of the vacuum cleaner.
You should perform the
test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
Table 7-2.
TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
VACUUM CLEANER MOTOR DOES NOT OPERATE.
Step 1.
Check power cord.
(a) If plugged in, proceed to step 2.
(b) Plug in power cord.
Step 2.
Check position of power switch.
(a) If turned on, proceed to step 3.
(b) Turn power switch on.
Step 3.
Check circuit breaker position in circuit breaker box.
(a) If turned off or tripped, turn circuit breaker on.
(b) If turned on, refer to supervisor.
7.3.3 There are no assigned Operator’s Maintenance Procedures.
7-8
