TM 5-3610-259-14
CAUTION
1.5.3.9
HOLE IN VAN BODY MUST BE COVERED TO PRE-
VENT DIRT, DUST, OR MOISTURE FROM ENTERING
VAN BODY OR DOUBLE WALL OF BODY, UNLESS
REPLACEMENT IS TO BE IMMEDIATELY INSTALLED.
12.
Attach lifting sling to replacement.
13.
Raise air conditioner/heater.
Then lower onto support frame.
Remove two sling hooks as unit is eased through hole until grille
contacts duct.
Remove remaining sling.
14.
Reinstall six mounting bolts.
15.
Reinstall duct and screws.
16.
Reinstall interior and exterior molding. Secure with screws and
seal molding to assembly.
17.
Reconnect drain line.
18.
Plug in power cord.
19*
Turn on circuit breaker.
Perform operational test.
REPLACE AIR CONDITIONER SUPPORT BRACKET.
TOOLS :
Tool Kit
Lifting Equipment
SUPPLIES: Air Conditioner Support Bracket
PERSONNEL: TwO
1-129