TM 5-3610-257-14
a.
Unplug power cord.
b.
Remove screws and right side cover.
c.
Tag and disconnect wiring at connectors and remove control panel.
NOTE
Tag electrical connections to be sure of proper reassembly.
d.
Loosen nut on POWER switch behind control panel. Unscrew and remove POWER switch protective cover.
Remove nut and defective switch from rear of control panel.
e.
Tag and disconnect wiring.
f.
Reconnect wiring to new switch and install switch.
g.
Reinstall nut and protective cover and secure switch with nut.
h.
Loosen setscrews on MOTOR SPEED control knob. Remove knob and securing nut and washer. Remove
control from rear of control panel.
i.
Tag and disconnect wiring.
j.
Connect wiring on new MOTOR SPEED control and install.
NOTE
Be sure control is set all the way to left and knob is pointing to lower setting.
k.
Reinstall securing nut and knob.
l.
Remove securing nut from FWD/REV switch.
m.
Tag and desolder wiring from defective switch.
n.
Solder wiring on new switch and install switch. Secure with retaining nut.
o.
Remove securing clip from fuse indicator lamp at rear of control panel. Tag and desolder wiring and
remove fuse indicator lamp from front of control panel.
p.
Install new fuse indicator lamp into front of control panel. Slip retaining clip over wiring and secure lamp to
rear of panel. Resolder wiring.
q.
Reinstall right side cover.
6-29
