TM 5-3610-252-14
Table 1-1. OPERATOR PREVENTIVE MAINTENANCE CHECKS ANC) SERVICES—Cont.
B—Before
W—Weekly
AN-Annually
(Number)-Hundreds of Hours
D—During
M—Monthly
S -Semiannually
A—After -
ITEM
NO.
1
2
1-18
IN-
TER-
VAL
B/D/A
Q
W
Q
B/D
W
W
D
W
D
Q —Quarterly
BI —Biennially
ITEM TO BE INSPECTED
PROCEDURE
VAN BODY—Cont.
Inspect Exterior-Cont.
10.
11.
11.1
12.
Inspect front and rear van body locks to be sure locks are fully
engaged.
Inspect gaskets on personnel doors for leaks or damage.
Inspect hinges for proper placement of hinge pins.
Clean and paint blistered, pitted, or flaking areas and bare metal
spots in accordance with instructions cntained in TM 43-0139,
Painting Instructions for Field Use,
Inspect Interior.
1.
2.
3.
4.
5.
6.
Change 2
Test emergency lights by pressing test button.
Inspect power cords and cables to be sure wires are not kinked,
cut, or cracked.
Inspect plug connectors to be sure all plug connectors are tight
and firmly seated. Tighten if necessary.
Inspect for burned out light bulbs and fluorescent lamps. Replace
as required.
Inspect walls, ceilings, and floor for holes, open seams, or signs of
seepage or leaks.
Check storage cabinets for broken hinges, latches, and locks.
For Readiness
Reporting,
Equipment Is
Not Ready/
Available If:
Lock disengaged.
Missing hinge pins.
Emergency lights
do not light.
Wires or cables
are cracked or cut.
Leaks are present.
Hinge, latch, or
lock is broken.
