TM 5-3610-252-14
Section IV ORGANIZATIONAL MAINTENANCE
5-11. LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
5-12 REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT; AND SUPPORT EQUIPMENT.
5-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
5-12.2 Special Tools: Test, Measurement, and Diagnostic Equipment: and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual .
5 - 1 2 . 3 R e p a i r P a r t s.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-3610-252-24P covering organizational maintenance for
this equipment.
5-13. SERVICE UPON RECEIPT.
5-13.1
Checking Unpacked Equipment.
Inspect the equipment for damage incurred during shipment. If the equipment
has been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c .
Check to see whether the equipment has been modified.
5-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are
no organizational PMCS procedures assigned for this equipment.
5-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES. There are no organizational
troubleshooting procedures assigned for this equipment.
5-16. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering organizational maintenance
functions for the furniture and cabinets.
task requires more than one.
b. After completing each maintenance
sure that equipment is properly function
Personnel required are listed only if the
procedure, perform operational check to be
ing.
5-3