TM 5-3610-252-14
Section Ill OPERATOR MAINTENANCE
2-8. LUBRICATION INSTRUCTIONS.
NOTE
These lubrication instructions are mandatory.
2-8.1 Wipe down all bare metal surfaces and exposed moving parts quarterly, using
HDO-30 oil (MIL-L-2104), Item 10 (Appendix E).
2-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation
or maintenance of the hydraulic pallet truck, or its components.
You should perform
the test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
Table 2-2. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
TRUCK WILL NOT RAISE.
Check reservoir for low fluid level.
If fluid is low, service hydraulic unit.
(a)
(b)
(c)
Remove two screws and reservoir cover.
Remove plug from reservoir.
Check fluid level in reservoir. Fluid level should be
1/8 in. (3.2 mm) below reservoir mouth.
2-11
