TM 5-6675-328-14
1-10.3 Replace Blackout/Dome Light.
MOS:
35E, Special Electronic Devices Repairer
or
41B, Topographic Instrument Repair Specialist
TOOLS: None
SUPPLIES: Lamp (12V)
Silicone Spray (Item 22, Appendix E)
NOTE
Blackout light and dome light are sealed units. No bulb replacement is possible. Complete light must be
replaced.
a.
Push light and gasket up into opening.
b.
Tilt and remove light and gasket from opening.
c.
Disconnect light from connector.
d.
Connect new light to connector.
e.
Reinstall gasket in opening.
NOTE
The use of silicone spray on the gasket will help to position light.
f.
Position light in gasket and push in.
1-52