TM 5-6675-328-14
Table 1-1. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES - Cont
B - Before
W - Weekly
AN - Annually
(Number) - Hundreds of Hours
D - During
M - Monthly
S - Semiannually
A - After
Q - Quarterly
BI - Biennially
ITEM TO BE INSPECTED
For Readiness
ITEM
IN-
Reporting,
NO.
TER-
Equipment Is
VAL
PROCEDURE
Not Ready/
Available If:
VAN BODY - Cont
1
Inspect Exterior - Cont
NOTE
When mounted on chassis, perform following step.
B/D/
10.
Inspect front and rear van body locks to be sure
Lock dis-
A
locks are fully engaged.
engaged.
Q
11.
Inspect gaskets on personnel doors for leaks or
damage.
W
11.1 Inspect hinges for proper placement of hinge pins.
Missing hinge
Pins.
Q
12.
Clean and paint blistered, pitted, or flaking
areas and bare metal spots in accordance with
instructions contained in TM 43-0139, Painting
Instructions for Field Use.
2
Inspect Interior.
B/D
1.
Test emergency lights by placing switch in
Emergency
ready position and pressing test button.
lights do
not light.
W
2.
Inspect power cords and cables to be sure wires
Wires or
are not kinked, cut, or cracked.
cables are
cracked or
W
3.
Inspect plug connectors to be sure all plug
cut.
connectors are tight and firmly seated. Tighten
if necessary.
D
4.
Check bulbs and fluorescent lamps. Replace if
necessary.
W
5.
Inspect walls, ceilings, and floor for holes,
Leaks are
open seams, or signs of seepage or leaks.
present.
D
6.
Check storage cabinets for broken hinges,
Hinge,
latches, and locks.
latch, or
lock is
broken.
Change 2
1-19
