Equipment Is Not Ready/Available If: Column

Section II. OPERATING INSTRUCTIONS (cont) - TM-5-6675-326-14_26

Table 1-1. Operator Preventive Maintenance Checks and Services

TM-5-6675-326-14 Topographic Support System Synthessis Section Model ADC-TSS-14 NSN: 6675-01-105-5763 Manual
Page Navigation
13

1-5 OPERATOR PREVENTIVE MAINTENCE CHECKS 1 - 5 . 1 G e n e r a l . T h e d i r e c t s u p p o r t s e c t i on inspected to find and correct defects. TM5-6675-326-14 AND SERVICES (PMCS). (van) must be regularly 1-5.1.1 Before You Operate. Always keep in mind the WARNINGS and CAUTIONS. Perform your BEFORE (B) PMCS. 1-5.1.2 While You Operate. Always keep in mind the WARNINGS and CAUTIONS. Perform your DURING (D) PMCS. 1-5.1.3 After You Operate. Be sure to perfom your AFTER (A) PMCS. 1-5.1.4 If Your Equipment Fails To Operate. Troubleshoot with the proper equipment. Report any deficiencies using the proper forms. See DA Pam 738-750. 1-5.2 PMCS Procedures 1-5.2.1 PMCS are designed to keep the equipment in good working condition by performing periodic service tasks. 1-5.2.2 Service intervals provide you, the operator, with time schedules that determine when to perform specified service tasks. 1-5.2.3 The “Equipment is Not Ready/Available If” Column is used for identification of conditions that make the equipment not ready/available for readiness reporting purposes or denies use of the equipment until corrective maintenance is performed. 1-5.2.4 If your equipment fails to operate after PMCS is performed, immediately report this condition to your supervisor. 1-5.3 PMCS Columnar Entries 1-5.3.1 Item Number Column. Item numbers are assigned in chronological ascending sequence regardless of interval designation. These numbers are used for your “TM number" Column on DA Form 2404, Equipment Inspection and Maintenance Worksheet in recording results of PMCS. 1 - 5 . 3 . 2 I n t e r v a l C o l u m n. This column determines the time period designated to perform your PMCS. 1-5.3.3 Item To Be Inspected and Procedures Column. This column lists functional groups and their respective assemblies and subassemblies as shown in the Maintenance Allocation Chart (Appendix B). The appropriate check or service procedure follows the specific item to be inspected. 1-5.3.4 Equipment Is Not Ready/Available If: Column. This column indicates the reason or cause why your equipment is not ready/available to perform its primary mission. 1-13

Privacy Statement
Press Release
Contact