TM 5-6675-325-14
d.
e.
f.
g.
h.
i.
j.
k.
1.
m.
n.
o.
p.
NOTE
Do not disconnect wires to transducer.
Remove three screws, one nut, and one washer holding
chassis.
Tag and disconnect power cord wires and power switch
board.
Disconnect capacitor wires from ci
Tag and disconnect two transducer
Remove defective circuit board.
Install new circuit board.
Reconnect
Reconnect
Reconnect
Reinstall
chassis.
Reinstall
washers.
two transducer wires to
rcuit board.
wires from circuit
circuit board.
capacitor wires to circuit board.
power switch wires and power cord wires to
circuit board to
wires from circuit
board.
circuit board.
one washer, one nut, and three screws holding circuit board
stainless steel tank and casing. Secure with screws and
Fill stainless steel tank 1/3 full with water.
Plug in power cord and turn power on.
agitates.
6-17. PREPARATION FOR STORAGE OR SHIPMENT.
and shipping instructions.
Section V DIRECT/GENERAL
Check that water surface
to
Contact your battalion for packing
SUPPORT MAINTENANCE
There are no direct/general support maintenance procedures assigned for this
equipment.
6-17/(6-18 blank)