TM 5-6675-325-14
CAUTION
Too high adjustment of bed cutter will cause premature failure of cutter
assembly.
d. Loosen two outer screws and then three inner screws.
e.
Move bed cutter slightly to obtain approximate settings noted in
step c.
Tighten two outer screws.
f. Tighten three inner screws.
g.
Reinstall rear paper loading door.
h. Plug in power cord.
i.
Make several prints to check operation of cutter. Readjust as
required.
3-16.10 Adjust Mirror Linkaqe.
MOS:
41B, Topographic Instrument Repair Specialist
TOOLS: Cross Tip Screwdriver
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a. Unplug power cord.
NOTE
Left and right on reader-printer are taken when viewed from front.
b. Remove rear panel.
3-78