Table 2-2. TROUBLESHOOTING.
TEST OR INSPECTION
LAWS DO NOT LIGHT
Step 1 l
Check that power switch is ON.
(a) If power switch is ON, proceed to step 2.
(b) Turn on power switch.
Check that power cord is plugged in.
(a) If power cord is plugged in, proceed to step 3.
(b) Plug in power cord.
Visually check fuse for broken filament.
(a) Replace fuse (paragraphs 2-10.1)
(b) If filament is not broken, refer to organizational
TABLE DOES NOT LOCK.
Check for loose tilt lock.
(a) If loose, tighten.
(b) If tight, refer to organizational maintenance.