TM 5-6675-324-14
j. Remove two screws and lift defective post cool thermostat clear of
spacer. Retain spacer and disconnect wires.
k. Fit new post cool thermostat with spacer underneath. Tighten screws and
reconnect wires.
1.
Reinstall print roller.
Reinstall exposure lamp and reflector assembly into frame. Reconnect
m.
exposure lamp leads.
Reinstall spring latches and secure with screws.
n.
Reinstall copy belt by sliding it over rollers from left to right.
o.
Center belt on roller.
Pull two rear latching levers forward and push them down.
P.
Rotate reflector lock down to locked position.
q.
r.
Plug in power cord and check machine for proper operation.
4-16.2 Adjust Drive Belt Tension.
MOS:
83FJ6, Reproduction Equipment Repairer
TOOLS: Cross Tip Screwdriver
WARNING
Death or serious injury may occur from electrical shock unless power cord is
unplugged before servicing.
Unplug power cord.
a.
4-63