TM 5-6675-319-14
(e) Feed negative (emulsion side up) over rollers, under mask, and
thread onto empty spool.
( f ) P o s i t i o n n e g a t i v e t o b e c o p i e d s o i m a g e a r e a c o i n c i d e s w i t h m a s k
c u t o u t .
( 2 5 ) T u r n o f f a l l l i g h t i n g e x c e p t a l l o w a b l e s a f e l a m p s.
NOTE
I f r o l l - p a p e r p r i n t i n g m a t e r i a l i s u s e d , f o l l o w s t e p s ( 2 6 ) t h r o u g h ( 3 5 ) .
I f c u t - s h e e t p r i n t i n g m a t e r i a l i s t o b e u s e d , p r o c e e d t o s t e p ( 3 6 ).
RPT.
( 2 6 ) T h r e a d r o l l - p a p e r p r i n t i n g m a t e r i a l o n p r i n t e r a s f o l l o w s :
(a) Insert empty spool on holder at right side of RPT.
( b ) I n s e r t r o l l - p a p e r p r i n t i n g m a t e r i a l o n h o l d e r a t l e f t s i d e of
(c) Thread printing material (emulsion side down) through left
roller assembly, over mask, through right roller assembly, and onto empty spool.
(27) Set APL single/multiple print switch to SINGLE.
(28) Turn on TRANSPORT POWER switch.
(29) Check for proper paper advance spacing as follows:
(a) Loosen thumbscrew and slide marker assembly from hood.
(b) Reinstall assembly with graphite wheel down.
( c ) A l i n e g r a p h i t e w h e e l w i t h m a r k e r t a b l e a t p r i n t s t a g e .
(d) Set RPT revolution counter to proper number, which is approximately
96 for 10 in. (25.4 cm) wide original with 3/4 in. (19.05 mm) spacing between
p r i n t s .
( e ) M a r k p a p e r by
raise hood.
When hood is lowered,
lowering hood without locking platen handle. Then
NOTE
marker assembly will place mark on paper.
(f) After paper advances, again lower hood without locking platen
handle and mark paper.
9-38