TM 5-6675-319-14
b. Remove screws and washers holding stainless steel tank and casing
t o c h a s s i s.
c .
L i f t s t a i n l e s s s t e e l t a n k a n d c a s i n g f r e e . S e t a s i d e.
NOTE
Do not disconnect wires to transducer.
d .
e.
f .
g .
h.
i .
j .
k.
l .
m.
Remove three screws, one nut, and one washer holding circuit board to
c h a s s i s.
Disconnect power cord wire from power switch, chassis ground, and
c i r c u i t b o a r d.
Loosen strain relief bushing from chassis and remove defective power
c o r d.
Install strain relief bushing on new power cord. Insert terminal ends
of cord into chassis.
F i t s t r a i n r e l i e f b u s h i n g i n t o c h a s s i s .
Reconnect power cord wire to circuit board, chassis, and power switch.
Reinstall circuit board into chassis and secure with one washer, one
nut, and three screws.
Reinstall stainless steel tank and casing. Secure with screws and
washers.
F i l l s t a i n l e s s s t e e l t a n k 1 / 3 f u l l w i t h w a t e r.
Plug in power cord and turn power on. Check that water surface
a g i t a t e s .
8-13