TM 5-6675-319-14
f . M o v e t i l t m o t o r s o t h at
g .
Remove defective belt.
belt can be slipped off drive pulley.
h. Open three belt clamps by removing attaching hardware, and slide out
one of spare belts.
i .
Secure remaining belts in clamps.
j .
Slide new belt down center shaft, and install it on shaft drive pulley.
k. Slip opposite end over motor drive pulley.
l .
Pull tilt motor toward front of rectifier to increase tension of belt.
m.
Tension is correct when you place your thumb halfway between pulley, and
belt depresses one inch.
n.
When correct tension is obtained, tighten motor mounting screws.
o.
Recheck tension.
p .
Reinstall base cover assembly.
q.
Plug in power cord and turn on circuit breaker.
r .
R e i n s t a l l d u s t c o v e r.
7-102