TM 5-6675-319-14
2-20.2 Repair Crossover Assembly.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Flat Tip Screwdriver
7/16 in. Combination Wrench
SUPPLIES:
As Required
NOTE
The following procedure is in disassembly/assembly
the crossover assembly only as far as necessary to
a.
Turn off DRIVE switch on processor.
sequence.
Disassemble
perform the repair.
b. Remove screws and both film guide shoes.
c .
Remove screw, lockwasher, washer, plastic gear with woodruff key,
spacer, and bearing from lower roller shaft.
d. Remove nuts from tie rod shafts on drive side plate.
NOTE
Washer removed in next step is identification washer and must be rein-
stalled in same place .
2-136