TM 5-6675-318-14
b. Remove screws and washers holding stainless steel tank and casing
t o c h a s s i s.
c.
L i f t s t a i n l e s s s t e e l t a n k a n d c a s i n g f r e e . S e t a s i d e .
NOTE
Do not disconnect wires to transducer.
d. Remove three screws, one nut, and one washer holding circuit board to
c h a s s i s .
e.
Disconnect power cord wire from power switch, chassis ground, and
c i r c u i t b o a r d.
f. Loosen strain relief bushing from chassis and remove defective power
c o r d .
g .
Install strain relief bushing on new power cord. Insert terminal ends
of cord into chassis.
h . F i t s t r a i n r e l i e f b u s h i n g i n t o c h a s s i s .
i .
Reconnect power cord wire to circuit board, chassis, and power switch.
j .
Reinstall circuit board into chassis and secure with one washer, one
nut, and three screws.
k. Reinstall stainless steel tank and casing. Secure with screws and
washers.
l .
F i l l s t a i n l e s s s t e e l t a n k 1 / 3 f u l l w i t h w a t e r.
m.
Plug in power cord and turn power on. Check that water surface
a g i t a t e s.
6-13