TM 5-6675-318-14
(c) Position paper squarely against ridge at bottom of platen and
against paper stop on left side. Smooth paper with back of hand.
(CHART LOAD lamp should go of f.)
(d) Press CHART HOLD switch.
(7) Load pens:
WARNING
To avoid possible injury to fingers, always turn plotter off when directly
storing pens.
(a) Turn LINE power switch to off (0).
(b) Remove cap from first pen.
(c) Place tip of pen in boot at base of stall.
(d) Gently press pen down and in until it snaps in place.
(e) Repeat for all pens.
(8) Connect HP-IB Interface bus to rear of plotter. Controller ROM should
Turn LINE power switch to on (I).
b e plugged into computer (HP9825A only).
(9) Perform dynamic test:
(a) Insert 9800 series test cartridge into computer.
( b ) Load test cartridge by pressing STOP, ERASE a, EXECUTE, RESET,
l b d 3 , and EXECUTE.
(c) When computer displays ENTER MODEL # TO BE TESTED, press 9872,
SHIFT, A, and CONTINUE.
3-165