TM 5-6675-317-14
m.
If lamp has been touched with bare fingers, clean lamp envelope with
cotton swab moistened with denatured alcohol.
n.
Insert lamp and socket into reflector, secure with spring clip. Socket
fits only one way.
o. Connect spade connector lugs to socket.
p.
Aline cover with large holes over screws.
Slide cover into position and
tighten screws.
q.
Slide light box under scope.
r. Plug in light box cord.
s. Lift light box until front rail is engaged on track. Then lower rear of
box.
t.
Plug in power cord.
3-20.2 Replace Pilot Light.
MOS :
41B, Topographic Instrument Repair Specialist
TOOLS :
Flat Tip Screwdriver
SUPPLIES:
Pilot Light
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a. Turn off power switch.
b.
Unplug power cord.
3-42