TM 5-6675-316-14
Table 8-2. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4.
COATING LAYER IS TOO THICK OR TOO THIN - Cent
Step 2.
Check that coating roller is seated properly in wax and carriage
support bar is not jammed.
Push down on both ends of coating roller. Free carriage support
bar if jammed.
5.
WAX COATING CONTAINS DUST PARTICLES OR DIRT.
Step 1. Check
(a)
(b)
Step 2. Check
that wax in tray is clear and has no suspended matter.
If wax is clear, proceed to step 2.
Drain and replace wax.
that wax on coating roller is clear with no foreign particles.
Clean coating roller.
8-29