TM 5-6675-315-14
s.
Reinstall cutter flange.
NOTE
The sequence of sprocket assembly installation is as follows: spring washer, Woodruff Key,
brass washer, sprocket, brass washer, spring washer, and locking nut with brass plug and
setscrew.
t.
Reinstall sprocket assembly.
u.
Secure cover plate with nuts and washers.
NOTE
Tighten nuts until 1-1/2 threads of stud show above nut.
v.
Reinstall cutter assembly in machine and secure with mounting bolts and washers.
w.
Reconnect motor wiring. Then reinstall gasket and cover.
x.
Reconnect centrifugal switch and tighten clamp.
NOTE
Be sure bail ejection switch plunger is in place before securing cover.
y.
Reinstall rear U-cover.
z.
Swing sprocket plate up, position on stud, and secure with washer and nut.
aa.
Reinstall conveyor belt sprocket, conveyor belt drive sprocket, and chain as an assembly.
ab.
Secure cutter drive sprocket with grip ring and tighten setscrews. Then reinstall washer and locking nut.
2-240