TM 5-6675-315-14
2-16.6
Adjust Conveyor Belt Tension.
MOS:
83FJ6, Reproduction Equipment Repairer
TOOLS:
No. 2 Cross Tip Screwdriver
Machinist Rule
4 mm Hex Head Key Wrench
13 mm Combination Wrench
WARNING
Death or serious injury may occur from electrical shock unless power is turned off before
adjusting conveyor belt.
a.
Turn circuit breaker off.
b.
Turn off main power switch.
c.
Move shredder-bagger away from wall (paragraph 2-16.21).
d.
Remove screws holding bottom of both cutter mechanism side panels.
NOTE
Top of cutter side panel hangs from brackets.
e.
Grasp cutter mechanism side panel at bottom and top. Remove cutter side panel by lifting straight up several
inches and then pulling away from machine. Repeat for second panel.
2-88