TM 5-6675-313-24P
b.
PART NUMBER INDEX. Part numbers in this index are listed by part number in ascending alphanumeric
sequence (i.e., vertical arrangement of letter and number combination which places the first letter or digit of each group
in order A through Z, followed by the numbers 0 through 9 and each following letter or digit in like order).
(1)
FSCM column. The Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code used to
identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
(2)
PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by
means of its engineering drawings, specifications standards, and inspection requirements to identify an
item or range of items.
(3)
STOCK NUMBER column. This column lists the NSN for the associated part number and
manufacturer identified in the PART NUMBER and FSCM columns to the left.
(4)
FIG. column. This column lists the number of the figure where the item is identified/located in
Sections II and III.
(5)
ITEM column. The item number is that number assigned to the item as it appears in the figure
referenced in adjacent figure number column.
5.
SPECIAL INFORMATION.
a.
USABLE ON CODE. The usable on code appears in the lower left corner of the Description column
heading. Usable on codes are shown as "UOC: ....... "in the Description Column (justified left) on the last line applicable
item description/ nomenclature. Uncoded items are applicable to all models.
b.
ASSOCIATED PUBLICATIONS. The publication listed below pertains to the Drafting Support System and
its components.
Publication
Short Title
LO 5-6675-316-14-12
Lubrication Order: Topographic Support System, Drafting Support Section
TM 5-6675-316-14
Topographic Support System, Drafting Support Section
TM 5-6675-316-14-HR
Hand Receipt: Topographic Support System, Drafting Support Section
6.
HOW TO LOCATE REPAIR PARTS.
a.
When National Stock Number or Part Number is NOT Known.
(1)
First. Using the table of contents, determine the assembly group or subassembly group to which the
item belongs. This is necessary since figures are prepared for assembly groups and subassembly
groups, and listings are divided into the same groups.
(2)
Second. Find the figure covering the assembly group or subassembly group to which the item
belongs.
(3)
Third. Identify the item on the figure and note the item number.
(4)
Fourth. Refer to the Repair Parts List for the figure to find the part number for the item number noted
on the figure.
(5)
Fifth. Refer to the Part Number Index to find the NSN, if assigned.
6
