TM 5-6675-250-20
2-18. CONTROL KNOBS, ECU PANEL (Continued)
L O C A T I O N / l T E M
A C T I ON
R E M A R K S
I N S T A L L A T I ON
2 . C o n t r o l k n o b
a.
Allow sufficient
binding.
b.
Install control knob (2) on control shaft.
N O TE
space between control knob and ECU panel to prevent
Tighten setscrews (1).
Apply MIL-S-22473,
Grade N, Form R
primer, item 5, Ap-
pendix C, to the two
set-screws and allow
to air dry for 5 sec-
ends. Apply locking
sealant MlL-S-46163,
Grade N, Type II, item
2, Appendix C, to the
first few threads of
two setscrews. Install
the setscrews partial-
ly into the control
k n o b.
2-5/(2-96 blank)