TM 5-3610-287-10
2-7.
PREPARATION FOR MOVEMENT (CONT)
1.
Turn petcock valve (1) to left to drain faucet.
NOTE
Be sure drain hose is attached to exterior drain line
on Section body.
2.
Turn gate valve (2) to left to drain water tank.
3.
Turn emergency light switch to OFF.
4.
Store interior accessories under sink and in cabinets.
NOTE
Securing equipment (wingnuts, securing bars, etc.) is
identified by its red color.
5.
Install securing bar on pile board storage rack.
6. Remove securing bar from side of sink cabinet and install across
sink doors. Secure with thumbscrew.
NOTE
Two people are required to perform the following step.
7. Place plate register punch (3) in front of feeder end (4) of
Printing Press. Place clamps (5) over floor openings and secure to floor
with transport handknobs (6).
8. Place safety cans (7) under plate register punch and secure to
ring bolts (8) with rubber straps (9).
9.
Prepare Printing Press for movement (TM 5-3610-286-10, para 2-9).
10. Unplug magnifier light (10) and secure with strap at rear of GTO
storage cabinet (11).
11. Remove securing bar from side of GTO storage cabinet (11) and
position across front of GTO storage cabinet. Secure bar with thumbscrew.
Lower viewing board.
12. Position GTO storage cabinet (11) with drawers facing cargo door
in front of delivery end (12) of Printing Press. Place clamps (13) over
floor openings.
13. Remove six transport handknobs (14) from sides of GTO storage
cabinet (11). Turn wheel handknobs (15) to lower GTO storage cabinet to
floor. Secure GTO storage cabinet with transport handknobs (14).
2-41